1z1-429 無料問題集「Oracle FS1 Series Systems Implementation Essentials」

（A）Go to the Data Protection tab and change the Load Balancing option for the specific LUN.

（B）Navigate to the System/Storage Profiles and double-click the profile to modify.

（C）Go to the Oracle FS Path Manager tab and change the Load Balancing option for the specific LUN.

（D）Navigate to the SAN/LUNs and double-click the LUN to modify.

（E）Navigate to the SAN/Hosts and double-click the host to modify.

（A）Support

（B）Primary Support

（C）Administrator1

（D）Administrator2

（A）topology

（B）verify string

（C）string-list

（D）verify-topology

（A）There is a policy to set up the data movement, such as Pin, Learn & Hold, Continuous.

（B）SSD tier in Auto-Tiering is used only for caching, not to store the data.

（C）Auto-tiering can be used as a mechanism to a change RAID level without service disruption.

（D）It works only with SSD and DRAM.

（A）1. Controller 1: Install CMA, plug and route cables Power first, Ethernet,SASController
Interconnects, SAS Controller to Strings and Front End Network Connections respectively.
2.Controller 2: Same as above.
3.DEs per string sequence.
4.Pilot 1: Install CMA, plug al cablesand route them Power first, Ethernet Last.
5.Pilot 2: Same as above.

（B）1. Pilot 1: Install CMA, plug all cables,and route them Power first, Ethernet last.
2.Pilot 2: Same as above.
3.DEs per string sequence.
4.Controller 1: Install CMA, plug and route cables Power first, Ethernet, SAS Controller
Interconnects, SAS Controller to Strings, and Front End Network Connections respectively.
5.Controller 2: Same as above.

（C）1. Controller 1: Install CMA, plug and route cablesPower first, Ethernet, SAS Controller
Interconnects, SAS Controller to Strings, and Front End Network Connections respectively.
2.Controller 2: Same as above.
3.Pilot 1: Install CMA, plug all cables, and route them Power first, Ethernet last.
4.Pilot 2: Same as above.
5. DEs per string sequence.

（D）1. Pilot 1: Install CMA, plug all cables, and route them Power first, Ethernet Last.
2.Pilot 2: Same as above.
3.Controller 1: Install CMA, plug and route cables Power first, Ethernet, SAS Controller
Interconnects, SAS Controller to Strings and Front End Network Connections respectively.
4.Controller 2: Same as above.
5.DEs per string sequence.

（A）fscli.exe

（B）FSonecli.exe

（C）pcli.exe

（D）pdscli.exe

（A）the FSCLI system command

（B）the FSCLI pilot command

（C）the FSCLI topology command

（D）the FSCLI profile command

（A）Typical Access

（B）I/O Bias

（C）Priority

（D）Enable Clones.

（E）Redundancy

（F）Allocated Capacity