300-535無料問題集「Cisco Automating and Programming Cisco Collaboration Solutions」

質問 1

Refer to the exhibit.

Which command prints out (44, 22) when this code is run on Python 3?

（A）print(swap2(22, 44))

（B）print(swap2(a, b))

（C）print(swap1(d, b))

（D）print(swap1(b, d))

正解：D 解答を投票する

質問 2

An automation engineer is trying to configure a destination group to use dial-out telemetry with gRPC on a Cisco IOS XR platform. The template created is failing to apply. Which parameters must be configured?

（A）source IP address, source port, encoding, and protocol

（B）destination IP address, destination port, encoding, and protocol

（C）destination IP address, destination port, encoding, and sensor path

（D）source IP address, source port, encoding, and sampling interval

正解：B 解答を投票する

解説: (JPNTest メンバーにのみ表示されます)

質問 3

Refer to the exhibit.

What are the two outcomes when the RESTCONF POST code is implemented? (Choose two.)

（A）An L3VPN endpoint to a VPN is updated.

（B）A new VPN endpoint to a VPN is added.

（C）An L3VPN endpoint to a VPN is merged.

（D）A new L3VPN endpoint to a VPN is added.

（E）An L3VPN endpoint to a VPN is replaced.

正解：A、D 解答を投票する

質問 4

Refer to the exhibit.

XTC has been configured by an engineer. What does the IPv4 address represent on the snippet?

（A）destination address of the router on which it listens for PCEP

（B）configured for the local peer for state synchronization

（C）configured for the remote peer for state synchronization

（D）local address of the router on which it listens for PCEP

正解：D 解答を投票する

解説: (JPNTest メンバーにのみ表示されます)

質問 5

Which two operations must be used to allow a network engineer to use NETCONF to configure and manage networking devices? (Choose two.)

（A）<remove-config>

（B）<put>

（C）<open-session>

（D）<close-session>

（E）<get-config>

正解：D、E 解答を投票する

質問 6

A user is debugging a problem with model-driven dial-in/out streams with gRPC for a Cisco IOS XR implementation. There is no streaming data and the path is not resolved when the show telemetry model- driven subscription command is issued on the router. What is the cause of the problem?

（A）SNMP is not enabled.

（B）There are polling interval problems.

（C）There is no support for IOS XR 64-bit.

（D）The emsd process is not running.

正解：D 解答を投票する

解説: (JPNTest メンバーにのみ表示されます)

300-535 無料問題集「Cisco Automating and Programming Cisco Collaboration Solutions」

弊社を連絡する

関連リンク

トップ試験