3605 無料問題集「Avaya Ethernet Routing Switch Implementation and Maintenance」

How many Ethernet Routing Switch (ERS) 4500 switches can be connected in a single stack?

A campus network requirement is to introduce Virtual Routing and Forwarding (VRF) in the existing Ethernet Routing Switch (ERS) 8600-based core. The technician has to configure VRF on the ERS 8600. Which statement represents the order for configuring a new VRF?

Which statement describes the specific mechanism available for managing the switch using a common IP address, regardless of which CPU is the primary?

A university campus network consists of an Ethernet Routing
Switch (ERS) 8000 and Ethernet
switches.
Recently
they implemented
Routed Split
Multi-Link Trunking (RSMLT) over a split Multi- Link Trunk (SMLT) configuration. What is the advantage of implementing RSMLT over SMLT?

Avaya recommends using RSMLT edge in place of VRRP with Backup Master,
when available what are two valid reasons for using RSMLT edge? (Choose two)
正解:
解説: (JPNTest メンバーにのみ表示されます)
While troubleshooting
a MultiLink
Trunking
(MLT) and split
MultiLink Trunking (SMLT) network a need arises to determine which link packets are traversing.
Which feature should be used to facilitate the troubleshooting?

By default the ERS 8000 is configured for warm standby. After installation of a new ERS solution with dual CPUs, which three actions need to be Perform on the ERS configuration to ensure high availability mode is enabled and will function correctly? (Choose three)

解説: (JPNTest メンバーにのみ表示されます)
Which
CLI command
is used to validate
that synchronization
for High Availability mode is set correctly?

To provide load distribution across two or more equal cost paths in a Layer 3
routing environment, the ECMP feature can be used to maximize load sharing.
Which two statements correctly describe the ECMP features? (Choose two)

正解:A、D 解答を投票する
Consider the following deployment requirements. Support 40 100 Mb/s VoIP telephones, each with a power requirement
of 6
Watt
Support 40 directly connected 1000 Mb/s Ethernet workstations with UTP cable. Support four 1Gb/s Ethernet uplinks to the core switch using multimode fiber. Which configuration is the minimum hardware required for an Ethernet Routing Switch (ERS) 8306 chassis that will support the above requirements?

弊社を連絡する

我々は12時間以内ですべてのお問い合わせを答えます。

オンラインサポート時間:( UTC+9 ) 9:00-24:00
月曜日から土曜日まで

サポート:現在連絡