600-504無料問題集「Cisco Implementing Cisco Network Programmability」

質問 1

When troubleshooting a performance problem in an application, which storage metric is the most relevant to application performance?

（A）encryption method

（B）available storage

（C）disk rotations per minute

（D）disk latency

（E）world wide port name

（F）VMFS oversubscription

正解：D 解答を投票する

質問 2

Which option is the ISO series of standards that is related to technical product documentation?

（A）S1000D

（B）ISO 21:1985

（C）RFC 2026

（D）ICS 01.110

（E）ISO/TS 80004

正解：D 解答を投票する

質問 3

Which two commands are needed to view load averages of a server to sample normal operation? (Choose two.)

（A）top

（B）vmstat

（C）dstat

（D）ps

（E）uptime

（F）iostat

正解：A、E 解答を投票する

質問 4

Refer to the exhibit

You try to connect to a network element using a Cisco onePK application. You get this error while running the application.Which option describes the issue?

（A）A firewall rule is blocking the onePK TCP connection to the router.

（B）A "session max" is configured on the router, and the number of sessions to the router has been exceeded.

（C）There is an error in the onePK application code, and an incorrect argument was passed in one of the APIs.

（D）An ACL is configured on router that does not allow the onePK application to establish a connection.

（E）There is no reachability to the network element through pings (ICMP). Routing must be checked.

正解：B 解答を投票する

質問 5

You are troubleshooting an application that installs application routes into the routing table of your core network routers.
Which serviceability feature helps to troubleshoot transient application routes?

（A）access to the application source code

（B）an entry in the router syslog when the application detects high router CPU

（C）a command to flush all application routes from the router

（D）limiting the application routes that can be installed to a /24 or greater

（E）an entry in the router syslog when an application route is installed or removed

正解：E 解答を投票する

質問 6

Refer to the exhibit

H1 cannot ping H2. You have a Cisco onePK application that allows you to apply an ACL matching traffic flow between H1 and H2, on the router interfaces.Which command do you enter from the CLI of each router to check if the ACL is applied on its interfaces?

（A）show run | in ip access-list

（B）show ip access-lists interface interface

（C）show ip access-lists

（D）show ip access-list dynamic

正解：D 解答を投票する

600-504 無料問題集「Cisco Implementing Cisco Network Programmability」

弊社を連絡する

関連リンク

トップ試験