642-997 無料問題集「Cisco Implementing Cisco Data Center Unified Fabric (DCUFI)」

（A）a dual-homed server to a single FEX that is connected to two Cisco Nexus 5500 Series
Switches

（B）a dual-homed server to two FEXs, each connected to two Cisco Nexus 5500 Series
Switches

（C）a single-homed server to a single FEX that is connected to two Cisco Nexus 5500
Series Switches

（D）a dual-homed server to two FEXs that are connected to one Cisco Nexus 5500 Series
Switch

（A）They allow reserve vNICs to be allocated out of the spares pool.

（B）They enable hardware-based failover.

（C）They allow dynamic vNICs to be reserved for fabric failover.

（D）They select the primary fabric association for dynamic vNICs.

（A）The licenses are applied to the MAC address of the Cisco DCMN system

（B）The licenses are applied to bootflash of the Cisco Network devices

（C）The licenses are applied using the Cisco DCNM.

（D）The licenses are applied using the CLI.

（E）The licenses are applied to the network device serial numbers

（A）configure dynamic vNICs

（B）configure DirectPath I/O support in vCenter

（C）configure vPC

（D）configure PTS on the VSM

（A）Place interface ethernet 199/1/1 in VLAN 4 in the N5K-2 configuration.

（B）Trunk four VLANs on interface ethernet 199/1/1.

（C）Add VLAN 4 to vPC 199.

（D）Prune all but four VLANs from vPC 199.

（E）Use the shut and no shut interface ethernet 199/1/1 so that the VLANs come up.

（A）N proxy virtualization

（B）N Port identifier virtualization

（C）Data Center Bridging

（D）Fibre Channel over Ethernet

（E）Fibre Channel

（A）It depends on the weighting values that are configured active on the router.

（B）The currently active router remains active.

（C）The Cisco Nexus switch becomes the active virtual gateway after 600 seconds.

（D）It depends on the priority value that is configured active on the router.

（A）Dynamic vNICs can only be bound to the service profile through an updating template.

（B）Dynamic vNICs are assigned by binding a port profile to the service profile.

（C）Dynamic vNICs are bound directly to a service profile.

（D）Dynamic vNICs are assigned to VMs in vCenter.

（A）The SGT Exchange Protocol must use the management (mgmt 0) interface.

（B）The hardware is not able to support MACsec switch-port-level encryption based on IEEE
802.1AE.

（C）The maximum number of RBACL TCAM user configurable entries is 128k.

（D）Cisco TrustSec support varies depending on Cisco Nexus 5500 Series Switch model.

（A）AAA

（B）VSS

（C）virtual switches

（D）domain parameters