CTAL-TM-UK無料問題集「ISQI ISTQB Certified Tester Advanced Level

質問 1

A test assessment has been carried out using the selected model as a reference framework. A number of recommendations have been identified and you are asked to prioritize them. Based on your knowledge of the project, you are expecting severe resistance to change. Which of the following would be the most important selection criterion for defining the priority of the recommendations? 2 credits

（A）Low costs actions first

（B）Defined according to the maturity model used

（C）Synchronized with the overall long-term organizational strategy

（D）Most visible to stakeholders

正解：D 解答を投票する

質問 2

Considerable attention will be given in this project to defining exit criteria and on reporting back on their status. Which combination of TWO exit criteria from the list would be best to use? 1 credit
I. Total number of defects found
II. Percentage of test cases executed
III. Total test effort planned versus total actual test effort spent
IV.
Defect trend (number of defects found per test run over time

（A）(ii) and (iii)

（B）(ii) and (iv)

（C）(i) and (iv)

（D）(i) and (ii)

正解：B 解答を投票する

解説: (JPNTest メンバーにのみ表示されます)

質問 3

In addition to introducing the new team member, you have decided to raise motivation. Which of the measures listed below would be the best measure to take in order to increase the motivation of the team? 2 credits

（A）Introduce entry criteria to the testing phase

（B）Organize a meeting with senior management in which they address the importance of good testing for this project

（C）Provide more time for testing in the schedule

（D）Allow people to take some time off

正解：B 解答を投票する

質問 4

Identify THREE items that would be part of the work-breakdown structure showing the key testing activities for the acceptance test project. 2 credits (for 2 out of 3 correct 1 credit)

（A）Regression testing in the second, third and fourth iterations

（B）Activities to deploy the system in the user environment

（C）Defining test environment requirements for system testing

（D）Test planning, test case preparation and test execution for each of the four iterations

（E）Work should be explicitly allocated to test completion, test management, installation and to training on using the system

（F）Reviews on requirements documentation

（G）Development activities for unit and integration testing

正解：A、D、E 解答を投票する

質問 5

In general, why is it NOT a good idea to estimate the testing effort based only on a percentage of development effort? Identify THREE valid reasons. 1 credit

（A）It builds on large set of historical data

（B）The maturity of the organization, e.g. the quality of the test basis, quality of development testing, configuration management, availability of test tools, also influence the effort needed for testing.

（C）The quality of the development estimate may be poor.

（D）The result is almost always a too low estimate for the required test effort

（E）The percentage based technique only applies to the V life cycle model.

（F）Using the same percentage every time does not address the level of risk of the application to be tested.

（G）In general bottom-up estimation is always better than top-down estimation.

正解：B、C、F 解答を投票する

質問 6

What would be a test approach regarding the test design techniques to be applied that would fit an item with the highest risk? 2 credits

（A）Component testing: statement testing; System testing: decision table partitioning

（B）Component testing: decision testing; System testing: decision table testing

（C）Component testing: decision testing; System testing: exploratory testing

（D）Component testing: statement testing; System testing: equivalence partitioning

正解：B 解答を投票する

解説: (JPNTest メンバーにのみ表示されます)

CTAL-TM-UK 無料問題集「ISQI ISTQB Certified Tester Advanced Level - Test Manager (CTAL-TM_UK)」

弊社を連絡する

関連リンク

トップ試験