D-PCM-DY-23無料問題集「EMC Dell PowerSwitch Campus Deploy 2023」

質問 1

When configuring a standard MAC ACL on a Dell EMC N-Series switch, how is the ACL filtered?

（A）Filtered based on the Source MAC address

（B）Filtered based on the Source IP address

（C）Filtered based on the Destination IP address

（D）Filtered based on the IP protocol number

正解：A 解答を投票する

質問 2

Based on the graphic, which command should be used on the Dell EMC N-Series Layer 2 switch to allow both client computers to receive a dynamic IP address?

（A）Console(config)# ip helper-address 192.168.100.250

（B）Console(config)# ip redirects

（C）Console(config)# service dhcp

（D）Console(config)# service-policy in dhcp_250

正解：A 解答を投票する

質問 3

What is a recommended configuration for an MLAG peer-link on a Dell EMC N-Series switch?

（A）Link must contain multiple interfaces

（B）Spanning tree must be disabled

（C）Spanning tree must be enabled

（D）Link must be a trunk port

正解：C 解答を投票する

質問 4

What is the IP protocol number, in decimal, assigned by IANA for VRRP?

（A）112

（B）1443

（C）25

（D）443

正解：A 解答を投票する

質問 5

Which Dell EMC N-Series models are ideal for data center aggregation and core tiers, providing optional dual hot-swappable power supplies?

（A）N1100, N2000, N3000, and N4000

（B）N2000 and N4000 only

（C）N3000 and N4000 only

（D）N1100 and N1500 only

正解：C 解答を投票する

質問 6

Which Layer 2 network protocol is used for automatic configuration of switch VLANs and dynamically manages VLAN membership on trunk ports?

（A）RSTP

（B）PVST

（C）MSTP

（D）GVRP

正解：D 解答を投票する

質問 7

What is the size of the 802.1Q header of a VLAN-tagged Ethernet frame?

（A）1512 bytes

（B）1518 bytes

（C）4 bits

（D）4 bytes

正解：D 解答を投票する

質問 8

N4032F#show interfaces status

N4032F#show interfaces port-channel 1

Hash Algorithm Type
- Source MAC, VLAN, EtherType, source module and port Id
- Destination MAC, VLAN, EtherType, source module and port Id
- Source IP and source TCP/UDP port
- Destination IP and destination TCP/UDP port
- Source/Destination MAC, VLAN, EtherType, source MODID/port
- Source/Destination IP and source/destination TCP/UDP port
- Enhanced hashing mode
N4032F#
A Dell EMC N-Series switch has been configured with a 2-member port-channel; however, only one link is currently active.
Based on the exhibit, why is only one link active?

（A）Minimum links value for Po1 is set to "1"

（B）Hash algorithm is configured for active-passive

（C）Te1/0/6 interface is administratively disabled

（D）Speed setting is different between ports

正解：D 解答を投票する

質問 9

Users report phone calls on VOIP phones have degraded audio quality and connection. Voice VLAN has already been configured on the switch interfaces.
What should be configured on the switch interfaces where phones are connected to prioritize VoIP traffic?

（A）switchport voice vlan dscp ef

（B）switchport voice vlan dot1p 64

（C）switchport voice vlan dscp 5

（D）switchport voice vlan dot1p 5

正解：D 解答を投票する

質問 10

Which L3 feature overrides routing protocol decisions and determines the forwarding of packets?

（A）RSTP

（B）SVI

（C）PBR

（D）SMTP

正解：C 解答を投票する

D-PCM-DY-23 無料問題集「EMC Dell PowerSwitch Campus Deploy 2023」

弊社を連絡する

関連リンク

トップ試験