D-PSC-MN-01 無料問題集「EMC Dell PowerScale Maintenance」

（A）Reboot the node and wait for a green status

（B）SmartFail the node and rejoin the cluster

（C）Ensure the install base record is updated

（D）Verify the node LNN is set to 1

（A）Back-end InfiniBand and Ethernet connectivity

（B）Back-end and front-end Ethernet connectivity

（C）Back-end InfiniBand or Ethernet connectivity

（D）Front-end Ethernet connectivity

（A）Must be on a separate subnet from int-b.

（B）Must be on the same subnet as int-b.

（C）Must use the same subnet as groupnet0, subnet0.

（D）Must use the same subnet as node 1, ext-1.

（A）Only enterprise and compliance SmartLock directories need to be reformatted.

（B）Enterprise, compliance, and secure SmartLock directories need to be reformatted.

（C）Only compliance and secure SmartLock directories need to be reformatted.

（D）Only enterprise SmartLock directories need to be reformatted.

（A）Diagnose the TPM

（B）Gather performance data.

（C）Diagnose the CPU.

（D）Gather cluster logs

（A）Transfer Rate = 57.600, Data Bits = 8, Parity = 1, Stop Bits = 0, Flow Control = Software

（B）Transfer Rate = 57.600, Data Bits = 7, Parity = 1, Stop Bits = 8, Flow Control = Hardware

（C）Transfer Rate = 115.200, Data Bits = 7, Parity = 1, Stop Bits = 1, Flow Control = Software

（D）Transfer Rate = 115.200, Data Bits = 8, Parity = None, Stop Bits = 1, Flow Control = Hardware

（A）CDMR

（B）WWFA

（C）DTFA

（D）DMR

（A）Support the node with both hands and slide it into the node bay.

（B）Close the module lever and slide the module into the chassis until it clicks.

（C）Loosen the thumbscrew on the release lever then slide the compute module into the chassis.

（D）Slide the release lever to the right and guide the node into the chassis.

（A）To monitor real-time network traffic

（B）For remote cluster management

（C）To execute file system commands

（D）For initial setup and configuration

（A）F600

（B）F810

（C）F900

（D）F200