H12-811-ENU 無料問題集「Huawei HCIA-Datacom V1.0」

The broadcast address is a special address in which the host bits in the network address are all set to 1, and it can also be used as a host address. ()

An AR2200 router needs to restore the initial configuration, which of the following operations are necessary? ()*

正解:B、C 解答を投票する
In the network shown in the figure below, what commands can be entered on the router to make host A ping host B through? ()

正解:C、D 解答を投票する
The subnet mask of a network segment 150.25.0.0 is 255.255.224.0, then () is a valid host address in this network segment. ()

The switch G0/0/1 port configuration information is shown in the figure. Which VLAN data frame does the switch forward without VLANTAG? ? () (Single-choice question)

Which of the following information is not included in the MAC address table of the switch? ()

If the Proto of a certain route information in the routing table is OSPF, the priority of this route must be 10. ()

Among the following commands for configuring the default route, the correct one is ()

The classic network forwarding method is based on router routing table forwarding. The forwarding method of OpenFlow switches is based on flow table forwarding. Which of these two forwarding methods are correct? ()*

正解:A、C、D 解答を投票する
What is the total length of an IPv6 address in bits? ()

What is wrong about the ARP message? ()

Which of the following statements about RA and RS in IPv6 are correct? ()

正解:A、B 解答を投票する
As shown in the broadcast network. 0SPF runs on four routers. And in the same area. Same network segment. OSPF will automatically elect one DR and multiple BDRs to achieve a better backup effect. ()(True or False)

What is the MAC address of the data link layer of each VAP on the AP? ()

A company applies for a C. address segment, which needs to be evenly distributed to 8 subsidiaries. The largest subsidiary has 14 computers. Different subsidiaries must be in different network segments. The subnet mask should be designed as ( )

What is the function of the command port trunk allow pass vlan all? ()

Users cannot configure VLAN ID. to 0. ()

弊社を連絡する

我々は12時間以内ですべてのお問い合わせを答えます。

オンラインサポート時間:( UTC+9 ) 9:00-24:00
月曜日から土曜日まで

サポート:現在連絡