HPE0-S58 無料問題集「HP Implementing HPE Composable Infrastructure Solutions」

An integrator is validating a Synergy solution configuration for a customer who requires connectivity to existing SAN switches. The interconnect modules selected are HPE Virtual Connect SE 40Gb F8 Module for HPE Synergy.
Which component must be in the configuration to meet this requirement?

Which technology used in HPE SimpliVity allows a reduction in storage consumption?

解説: (JPNTest メンバーにのみ表示されます)
A customer requires all automated Fibre Channel zones to have a prefix of "SYNERGY" in the automatically-generated zones.
Click where the integrator should change the naming policy.
正解:
Refer to the exhibit.

An integrator needs to create a volume on the FC_r6 CPG using HPE Composer, but the CPG is not available for provisioning. The integrator checked the Storage Pools section, and the CPG is visible.
What must the integrator do to enable volume provisioning on this CPG?

Which approach should an integrator take to efficiently configure a 10-frame Synergy environment that has been fully populated with compute nodes?

A customer needs to aggregate uplink ports from two Virtual Connect interconnects to increase bandwidth and availability of the networks configured for HPE Synergy platform.
Which steps must the integrator perform in the configuration to meet the customer's needs?

In a 3-frame HPE Synergy environment, how should an integrator place the image Streamer modules to allow for redundancy to all of the management connections?

解説: (JPNTest メンバーにのみ表示されます)
Refer to the exhibit.

A customer has an HPE Synergy 2-frame configuration, as shown. The customer has a new project and needs to increase the number of compute modules.
What is the maximum number of compute nodes that the customer's fabric could support?

A customer is planning an HPE Synergy solution with 20 frames and needs to minimize the number of management ports that are required to connect the frames into the existing management network.
Which procedure should the integrator use to address the customer's concern?

A customer needs an integrator to add HPE 3PAR StoreServ to the HPE Composer. When the integrator tries to add it, they get an error and 3PAR is not added.
What should the integrator check that may be causing this error?

弊社を連絡する

我々は12時間以内ですべてのお問い合わせを答えます。

オンラインサポート時間:( UTC+9 ) 9:00-24:00
月曜日から土曜日まで

サポート:現在連絡