HPE2-T37 無料問題集「HP Using HPE OneView」

（A）A Rack Management Controller

（B）An iL0 in an HPE ProLiant server

（C）Any supported HPE storage array

（D）An iL0 in an HPE Synergy compute node

（A）HPE OneView can be used to configure volume replication between these pools

（B）Both storage pools have a license applied that enables management of these pools

（C）Volumes created on the first storage pool cannot use data reduction technologies

（D）Both storage pools are in a managed state and can be used for volume provisioning

（A）Users with Backup Administrator privileges can restore an HPE OneView backup

（B）Only users with Infrastructure Administrator privileges can restore an HPE OneView backup

（C）An HPE OneView backup can be used to restore individual components like server profile

（D）During backup restore, users with Administrator privileges can still login to HPE OneView

（A）Global Dashboard licenses

（B）HPE OneView licenses

（C）FC Upgrade licenses

（D）Virtual Connect licenses

（A）A dedicated license must be added to HPE OneView to enable this feature.

（B）Firmware on the master modules is too low to support highly available setup.

（C）There are not sufficient frames for highly available setup.

（D）Some master modules only support a redundant setup.

（A）The HPE OneView certificate from the primary site must be added to HPE OneView in the remote site.

（B）Multi-site licenses must be added to HPE OneView and activate for all available HPE Synergy frames.

（C）The IP address assigned to HPE Composer installed in a remote site must be registered in a primary site.

（D）Management ports of the remote frame link topology must be connected to the management LAN.

（A）network purpose will impact the traffic only if Virtual Connect modules are used

（B）network purpose can give higher priority for a specific type of traffic

（C）network purpose will define QoS within Logical Interconnect

（D）network purpose does not affect the behavior of the network

（A）All memory installed must be the maximum size.

（B）A server profile template must be created.

（C）A second processor must be installed.

（D）An appropriate HPE OneView license is required.

（A）It supports HPE OneView instances from version 8.40 or newer.

（B）It is available for customers that have more than three HPE Synergy Frames.

（C）It supports HPE ProLiant G6 and newer systems regardless of the OS installed.

（D）It can be used tree of charge for the HPE Synergy platform because the licenses are included.