HPE6-A46無料問題集「HP Delta-Aruba Certified Switching Professional」

質問 1

A network administrator needs to find the source of a performance issue. The administrator has seen that interfaces sometimes start to drop many packets, but the issue is intermittent, and the administrator is not sure exactly when it happens. The administrator wants to be alerted when interfaces start to drop packets. The switches already have an SNMP trap server configured on them.
What else should an administrator do on these switches?

（A）Set up RMON alarms on dropped packet statistics

（B）Enable link change SNMP traps on the switch

（C）Enable debugging to the session

（D）Set the trap server to inform mode

正解：D 解答を投票する

質問 2

Refer to the exhibits.
Exhibit 1

Exhibit 2

The network administrator needs to set up BGP between the two company switches, Switch-1 and Switch-2.
The BGP connection does not establish. Based on the exhibits, what does the administrator need to do to fix the issue?

（A）Set the update source for the neighbor to the local loopback interface on each switch.

（B）Enable the multihop option for the neighbor on each of the switches.

（C）Enable BGP on the interfaces that the switches use to reach each other.

（D）Enter the network command for 10.0.0.0/24 in the router BGP mode on each switch.

正解：A 解答を投票する

質問 3

Two AOS-Switches are directly interconnected. The network administrator wants to prevent broadcast storms and other Layer 2 issues that could occur if there is physical damage to a cable.
Which technology should the administrator implement on the connected switch interfaces?

（A）Unidirectional Link Detection (UDLD)

（B）Spanning Tree Root Guard

（C）MAC Lockdown

（D）Bidirectional Forwarding Detection (BFD)

正解：A 解答を投票する

質問 4

A customer wants access layer switches that support routing, ACLs, VSF stacking, and SFP+. Which Aruba switch model meets the customer's requirements?

（A）2530

（B）8400

（C）3810

（D）2930F

正解：D 解答を投票する

質問 5

Refer to the exhibits.
Exhibit 1

Exhibit 2

Which change to the environment would cause clients to fail to receive DHCP settings?

（A）the addition of a new VLAN on the link aggregation between Switch-1 and Switch-2

（B）a change in the Switch-1 option 82 policy to replace

（C）the addition of a new link to the link aggregation between Switch-1 and Switch-2

（D）a change of IP address on the network DHCP server

正解：B 解答を投票する

質問 6

A network administrator needs to create a backplane stack with four AOS-Switches. The administrator wants to choose which switch becomes the commander. Which procedure meets those needs?

（A）Configure backplane switching settings on each switch while disconnected. Make sure the desired commander has member ID 1. Then, connect the switches.

（B）Configure backplane switches settings on each switch while disconnected. Make sure the desired commander has priority value 1. Then, connect the switches.

（C）Boot all of the switches at the same time and then connect the backplane stacking links. Then, access the desired commander, and make sure it has member ID 1.

（D）Boot up the desired commander first and make sure stacking is enabled on it. Then, connect the stacking links and boot the other switches.

正解：A 解答を投票する

質問 7

What is a reason to implement PIM-DM as opposed to PIM-SM?

（A）to obtain the simplest setup in a network with high bandwidth

（B）to control exactly which multicast groups are routed through the network

（C）to permit a higher density of rendevous point (RP) routers in the network core

（D）to conserve bandwidth over WAN links

正解：A 解答を投票する

質問 8

A customer wants to authenticate AOS-Switch managers to a RADIUS server. Managers should be assigned either read-only or full read-write level access based on the Service-Type VSA in their user account.
What must the network administrator enable on the AOS-Switches to ensure they comply with this plan?

（A）SNMPv3 and SNMPv3 restricted access.

（B）a manager and operator password

（C）privileged-mode login authentication

（D）RADIUS-based command authorization

正解：D 解答を投票する

質問 9

A network administrator applies port security to a port with the send-alarm action. What does the switch do if it detects traffic from an unauthorized MAC address on the port?

（A）It forwards the traffic, and it logs an event.

（B）It blocks the traffic, and it sends an SNMP trap.

（C）It disables the port, but sends no SNMP trap.

（D）It blocks the traffic, but sends no SNMP trap.

正解：C 解答を投票する

質問 10

Refer to the exhibits.
Exhibit 1

Exhibit 2

Exhibit 2 shows IGMP groups on Switch-2, which runs IGMP but not PIM. Switch-1 and Switch-3 do not have IGMP or PIM enabled. Client 1 begins to forward multicasts to 239.1.1.1.
Which clients receive the multicasts?

（A）Client 2, but not any of the other clients

（B）Client 2, Client 3, and Client 4

（C）Client 3 and Client 4, but not Client 2

（D）Client 3, but not any of the other clients

正解：A 解答を投票する

HPE6-A46 無料問題集「HP Delta-Aruba Certified Switching Professional」

弊社を連絡する

関連リンク

トップ試験