HPE6-A72無料問題集「HP Aruba Certified Switching Associate」

質問 1

Refer to the exhibit.

The above output is the result of issuing the command show system resource-utilization. What command should be used to enable terminal output line by line or page by page?

（A）The command less

（B）The command more

（C）The command terminal length 30

（D）The command page

正解：D 解答を投票する

質問 2

Refer to the exhibit.

Traffic is failing between Core-1 and Host-B. IP addressing has correctly been applied, and all interfaces are attached to the vrf GREEN.
Which configuration will correct the issue?

（A）Core-1(config)# ip route 10.1.20.0/24 10.1.1.2 vrf GREEN Host-B: assign the default-gateway address
10.1.20.181

（B）Core-2(config)# ip route 0.0.0.0/0 10.1.1.1 vrf GREEN Host-B: assign the default-gateway address
10.1.20.181

（C）Core-1(config)# ip route 10.1.20.0/24 10.1.1.2 vrf GREEN Host-B: assign the default-gateway address
10.1.20.1

（D）Host-B: assign the default-gateway address 10.1.20.181

正解：A 解答を投票する

質問 3

Refer to the exhibit.

What VSF command produces the above output?

（A）show vsf topology

（B）show vsf detail

（C）show vsf link

（D）show vsf member

正解：A 解答を投票する

質問 4

Refer to the exhibits.

The AOS-CX 6300M switch is attempting to configure VSF with a peer CX 6300F switch. What is one reason you are receiving the above error when attempting to configure VSF on the AOS-CX 6300M switch?

（A）Link 1 cannot be used if the attached CX 6300F VSF member 2 has already assigned link 1

（B）The port1/1/21 has been shutdown

（C）VSF Is not possible between CX 6300M and CX 6300F AOS-CX switches.

（D）AOS-CX VSF links can only be applied to uplink ports with 10G, 25G. and 50G speeds.

正解：A 解答を投票する

質問 5

Which network category applies to a SOHO internal network?

（A）LAN

（B）SD-WAN

（C）Internet

（D）WAN

正解：C 解答を投票する

質問 6

What are two key features unique to AOS-CX that support root cause analytics and recovery in a wired network? (Select two.)

（A）REST APIs

（B）Redundant management modules

（C）Network Analytics Engine

（D）Multi-Protocol Border Gateway Protocol (MP-BGP)

（E）Checkpoints

正解：C、E 解答を投票する

質問 7

Which command will suppress LLDP messages from egressing on a given port while still allowing LLDP to be enabled on the switch?

（A）switch(config-if)# no lldp receive

（B）switch(config-if)# no lldp interface (port) transmit

（C）switch(config-if)# no lldp transmit

（D）switch(config)# no lldp

正解：C 解答を投票する

質問 8

What are the benefits of a 3-Tier design over a 2-Tier? (Choose two.)

（A）Better scalability in a campus with a large number of buildings.

（B）Gaining the flexibility to connect the Data-Center to any Access layer switch.

（C）Lowering the cost of a deployment due to needing less switches overall.

（D）Can use lower speed links between Core to Aggregation and Aggregation to Access given the use of an Aggregation layer.

（E）Offloading processing from the Core without routing at the Access layer.

正解：A、E 解答を投票する

質問 9

Currently, the prompt on the AOS-CX switch displays:
Core-1(config)# interface 1/1/1
_Core-1 (config-if)#_
What command will immediately return the prompt to privileged mode?

（A）The command quit

（B）The command end

（C）pressing ctrl+w

（D）The command exit

正解：D 解答を投票する

質問 10

Refer to the exhibit.

The command show LLDP neighbor-info gets typed into Access-1. All switches are Aruba OS-CX switches.
What is the output of this command?

（A）Option D

（B）Option B

（C）Option C

（D）Option A

正解：A 解答を投票する

HPE6-A72 無料問題集「HP Aruba Certified Switching Associate」

弊社を連絡する

関連リンク

トップ試験