HPE7-A01無料問題集「HP Aruba Certified Campus Access Professional」

質問 1

When configuring UBT on a switch what will happen when a gateway role is not specified?

（A）The gateway will assign a default role to the client

（B）The gateway will send back the deny role to the client.

（C）The switch will put the client on the access VLAN

（D）The switch will assign the default deny role to the client.

正解：D 解答を投票する

解説: (JPNTest メンバーにのみ表示されます)

質問 2

You are configuring Policy Based Routing (PBR) for a subnet that will be used to test a new default route for your network Traffic originating from 10.2.250.0/24 should use a new default route to
10.1.1.253. Other non-default routes for this subnet should not be affected by this change.
What are two parts of the solution for these requirements? (Select two.)

（A）

（B）

（C）

（D）

（E）

正解：C、E 解答を投票する

質問 3

A company recently upgraded its campus switching infrastructure with Aruba 6300 CX switches. They have implemented 802.1X authentication on edge ports where laptop and loT devices typically connect.
An administrator has noticed that for PoE devices the pons are delivering the maximum wattage instead of what the device actually needs Upon connecting the loT devices, the devices request their specific required wattage through information exchange

（A）implement a classifier policy with the correct power definitions.

（B）Concerned about this waste of electricity, what should the administrator implement to solve this problem?

（C）Create device profiles with the correct power definitions.

（D）Enable AAA authentication to exempt LLDP and/or CDP information

（E）Globally enable the QoS trust setting for LLDP and/or CDP

正解：C 解答を投票する

解説: (JPNTest メンバーにのみ表示されます)

質問 4

Select the Aruba stacking technology matching each option (Options may be used more than once or not at all.)

正解：

Explanation:
a) Support up to 10 devices per stack -> VSF
b) Support two devices per stack -> VSX
c) Individual ISL links up to 400G are supported -> VSX
d) individual ISL links up to 50G are supported -> VSF
e) A maximum aggregate ISL bandwidth of 200G is supported -> VSF
References: 1 https://www.arubanetworks.com/techdocs/AOS-CX/10.04/HTML/5200-6728/GUID-
2E425DAE-EC54-4313-9D

質問 5

Your customer is interested in hearing more about how roles can help keep consistent policy enforcement in a distributed overlay fabric How would you explain this concept to them''

（A）Role-based policies are tied to IP addresses which have an advantage over IP-based policies and role names are sent between VTEPs

（B）Group Based Policy ID is applied on egress VTEP after device authentication and policy is enforced on ingress VTEP

（C）Role-based policies enhance User Based Tunneling across the campus network and the policy traffic is protected with iPsec

（D）Group Based Policy ID is applied on ingress VTEP after device authentication and policy is enforced on egress VTEP

正解：D 解答を投票する

解説: (JPNTest メンバーにのみ表示されます)

質問 6

The administrator notices that wired guest users that have exceeded their bandwidth limit are not being disconnected Access Tracker in ClearPass indicates a disconnect CoA message is being sent to the AOS-CX switch.
An administrator has performed the following configuration

What is the most likely cause of this issue?

（A）Change of Authorization has not been globally enabled on the switch

（B）There is a time difference between the switch and the ClearPass Policy Manager

（C）The SSL certificate for CPPM has not been added as a trust point on the switch

（D）There is a mismatch between the RADIUS secret on the switch and CPPM.

正解：A 解答を投票する

質問 7

By default, Best Effort is higher priority than which priority traffic type?

（A）Background

（B）Network Control

（C）Internet Control

（D）All queues

正解：A 解答を投票する

解説: (JPNTest メンバーにのみ表示されます)

質問 8

For an Aruba AOS10 AP in mixed mode, which factors can be used to determine the forwarding role assigned to a client? (Select two.)

（A）Client VLAN

（B）802.1X authentication result

（C）Client SSID

（D）Client IP address

（E）Client MAC address

正解：B、C 解答を投票する

解説: (JPNTest メンバーにのみ表示されます)

質問 9

You are deploying Aruba CX 6300's with the customers requirement to only allow one (1) VoIP phone and one (1) device.
The following local role gets assigned to the phone
port-access rote VoIP device-traffic-class voice
What set of commands best fits this requirement?

（A）interface 1/1/1
aaa authentication port-access client-limit 1
aaa authentication port-access auth-mode device-mode

（B）interface 1/1/1
aaa authentication port-access client-limit multi-domain 2
aaa authentication port-access auth-mode multi-domain

（C）interface 1/1/1
aaa authentication port-access auth-mode multi-domain

（D）interface 1/1/1
aaa authentication port-access client-limit 2
aaa authentication port-access auth-mode client-mode

正解：B 解答を投票する

解説: (JPNTest メンバーにのみ表示されます)

質問 10

Which standard supported by some Aruba APs can enable a customer to accurately locate wireless client devices within a few meters?

（A）802.11mc

（B）802.11k

（C）802.11r

（D）802.11W

正解：A 解答を投票する

解説: (JPNTest メンバーにのみ表示されます)

HPE7-A01 無料問題集「HP Aruba Certified Campus Access Professional」

弊社を連絡する

関連リンク

トップ試験